Stone Powder Grinding Equipment Wearing Parts Wear Rule And Maintenance Method
2018-08-15 03:31:08
Stone Powder Grinding Equipment wearing parts wear rule and maintenance method
Whether each
Stone Powder Grinding Equipment can always be in normal working state lies in the working condition of each zero and component constituting the stone powder grinding equipment, and how the working condition of each component depends on the amount of wear of each component. Because the stone powder grinding equipment is in operation, each piece and part will have different degrees of wear. In order to master the wear of the zero and parts, and correctly repair the three-ring mill equipment, the wear law must be studied.
Practice has proved that all the ultra-fine stone powder grinding equipment can be strictly operated, and the daily maintenance and maintenance will be carried out, which will reduce the wear of the parts, prolong the service life of the ultra-fine stone powder grinding equipment, and improve the ultra-fine The utilization rate of the stone powder grinding equipment, on the contrary, violates the operating rules of the ultra-fine stone powder grinding equipment, does not strengthen the daily maintenance and maintenance will increase the wear of the parts, and even accidents and premature maintenance, this This reduces the utilization of stone powder grinding equipment.
The amount of wear of a part is determined by a series of factors. Generally speaking, it is mainly the working ring of the part, the magnitude of the load, the working temperature, the speed of relative motion between the parts, the type of friction and wear, and the lubricating oil. The quantity and quality of lubrication, the size of the clearance between the parts, and the daily operation of the ultra-fine stone powder grinding equipment and the advantages and disadvantages of daily maintenance.
We study the wear law of parts, which is to study the characteristics of zero and component wear of ultra-fine stone powder grinding equipment. When the wear amount of the part increases to the maximum allowable limit, it must be repaired or replaced, so that the normal working performance of the ultra-fine stone powder grinding equipment can be restored and the working efficiency should be achieved.